DenTek Dental First Aid Kit
Instant pain relief
10% Combination Discount
- Buy 2 for £12.50 each and save 11%
Order Today, Shipped *Today
Free Shipping Over £60
100% 30-day Money Back Guarantee
Shop with Confidence
DenTek Dental First Aid Kit
First aid for toothache, broken teeth, lost fillings and broken crowns
Helps to solve various urgent dental accidents from dislodged teeth to lose caps and crowns. Dentek Dental First Aid Kit is there to provide you with a quick and convenient short-term fix for replacing a lost tooth filling cap, crown or inlay. It can help to restore function until you’re seen by a dentist.
Product Features & Key Benefits
- Temporarily remedy for replacing a lost filling cap, crown or inlay
- Eugenol – helps to anesthetize and disinfect the affected area
- Applicator and spade tool for ease of application
- Tooth saver vial provided for protecting broken or whole teeth
- The temporary filling material uses the same ingredients used by dentists
How to use DenTek First Aid Kit?
Directions to replace a lost filling: Wash the cavity area with warm water to remove food particles. Saturate tip of a fresh cotton swab applicator with liquid from the Eugenol vial and apply to tooth. Avoid touching surrounding gum tissue, cheek, or tongue with a wet applicator tip. Do not leave the applicator in your mouth. The Eugenol will help the filling material set up and adhere to the tooth enamel. Cut with a spade tool or pinch a small amount of Temparin Max from the vial, and roll into a ball between fingers. Slightly overfill the cavity with Temparin Max and tamp into place with applicator tooltip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple of times to create a comfortable bite. Use a moist cotton swab to remove excess Temparin Max from around the area. Moisture will accelerate the set. Temparin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.
Directions to secure loose crowns, caps, or inlays: Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, or if the remaining tooth is cracked, then do not proceed further. If the crown has a post attached to it or if there is a tooth surface remaining inside the crown, Temparin Max may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Cut with a spade tool or pinch a small amount of Temparin Max from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. Temparin Max will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.
Ingredients for Temparin Max: Zinc Oxide Powder, Calcium Sulphate, Petroleum Jelly, Potassium alum, Paraffin, Aluminum Sulphate, Aluminum Phosphate, Menthol Crystals, Eugenol, Yellow Iron Oxide
Ingredients for Eugenol: Eugenol, Sesame Oil
